Hantek DSO-5202B No signal and no buttons

amy · Post time 2017-11-22 08:25:26

Rogerm replied at 2017-11-22 03:40
Can it be the FPGA EP3C5F256C8N? I think this is the chip that carries.
Do you have the file?
To try ...

Sir, are you sure the software of EPM240T100C5 is programmed successfully?
Please give us a video of current fault phenomena.

Rogerm · Post time 2017-11-22 03:40:47

Edited by Rogerm at 2017-11-22 07:59

Can it be the FPGA EP3C5F256C8N? I think this is the chip that carries.
Do you have the file?
To try.
Thank you

Rogerm · Post time 2017-11-21 22:31:44

Hello:
I have already changed the EPM240T100C5 and programmed and continue doing the same.

Rogerm · Post time 2017-11-20 11:23:02

Thank you.
I have already received the file as soon as the EPM240T100C5 chip arrives and I got it programmed and welded it to him.

A greeting.

amy · Post time 2017-11-20 08:39:16

Rogerm replied at 2017-11-17 18:42
Hello:
If you can send me the software, I thank you, I'll try to program it.

Sir, I have sent the software to your email. Please check.

Rogerm · Post time 2017-11-17 18:42:57

Edited by Rogerm at 2017-11-17 19:04

Hello:
If you can send me the software, I thank you, I'll try to program it.

From what I see you can program it put on the plate the EPM240T100C5.
I have the Altera USB Blaster that is compatible with Altera Max II

Thank you very much for your time.

marcudios@yahoo.es

amy · Post time 2017-11-17 16:52:01

Rogerm replied at 2017-11-17 10:33
I worked 5 minutes once, I do not understand anything.

Sir, we can send the software for the EPM240T100C5. But need an expensive tool to program the CPLD software.
You can consult with your seller to return factory for repair or repalce it.

Rogerm · Post time 2017-11-17 10:33:10

I worked 5 minutes once, I do not understand anything.

Rogerm · Post time 2017-11-16 21:11:28

Edited by Rogerm at 2017-11-17 02:55

Go, then to throw the oscilloscope, to get the software will be impossible.
I put a new crystal of 100 MHZ and nothing remains the same.
Without glass the buttons obey something.
With a 50MHZ crystal it worked for about 2 minutes and then it locked again.
I have ordered an EPM240T100C5.
To continue repairing.
I do not know where to get the software for the EPM240T100C5
Greetings and thank you.

amy · Post time 2017-11-16 14:42:45

Edited by amy at 2017-11-16 14:46

If the problem is the same the YouTube video.
Maybe the chip (U702) is fault. The model of the chip is EPM240T100C5. And it need to be burned CPLD program.

Hantek DSO-5202B No signal and no buttons

This post contains more resources

Viewed forums