DSO Network Configure

WisdomAugust

1. Power up the oscilloscope, and connect it to PC by a NetworkCable.

2. Configure PC mainframe network settings

2.1 Open “My Network Places”

2.2 Select “View network connections”

2.3 Click “Local Area Connection”, and select “Properties” in the pop up menu.

2.4 Double click “Internet Protocol (TCP/IP)”

2.5 Select “Use the following IP address”

2.6 Fill the corresponding IP data in “Use the following IP address” option. Here take 192.168.1.2 for example.

2.7 Then click “OK” button, see below picture.

3. Obtain oscilloscope’s network parameters

    The default IP address of the oscilloscope is 192.168.1.20, and the network configuration data is as follows.

Usually, user needn’t to modify the oscilloscope’s network configuration information. If modified the IP but forget it, user is able to find it out on the software through connecting the oscilloscope to PC by a USB cable.

4. Test and verify the correctness of oscilloscope’s network configuration.

When finished the above steps, user is able to test the network configuration’s correctness by following method.

4.1 Click “start” in the PC mainframe system toolbar, and click “Run” in the pop up dialog box.

4.2 Input “cmd” in the pop out dialog box, and click “OK” button.

4.3 In the pop up command line input “ping 192.168.1.20” and press enter button. “192.168.1.20” is the default IP address of the oscilloscope. If user modified the IP, please input the new IP.

If there’re following information come up, it means the network configured successfully. If not, please configure the network again.