DSO5102P bricked on main screen

lggomez

I finally got a 4GB card. The tools still don't look like doing anything to the copied files and I get the following error



I need advice to know if this is still recoverable and if so then some new way to make the sd card bootable (it that's the issue)

lggomez

Jing replied at 2022-11-21 16:36
Dear Sir，
This programming operation must use a 4G SD card.

Ok, will have to get a card of that exact size then and try again, right?

lggomez

I'm trying with a 2GB sdcard and it doesn't get recognized by the device, it's a black screen. The software does nothing at all and I don't have a way to know if anything happens or not



This is unusuable, I already had to get the trouble of creating an XP virtual machine and the 2GB sd card for nothing, please provide another bootloader version or way to format the sd card if available

mork

Jing, you are speaking to two different posters here.

Jing

lggomez replied at 2022-11-19 06:39
Is the 4GB SD card a hard limitation? I tried to flash with a 32GB card with a 4GB FAT partition but ...

Dear Sir，
This programming operation must use a 4G SD card.

mork

SN T 1G/036 001682

Scope attempts to read the SD card but after a few seconds just goes to regular screen and gives error message and hangs.

Anyone help with this please?

mork

I used a dedicated 4g thumb drive. They say SD card in the instructions, but I am assuming it goes into the USB port in the front?
Also, the instructions for setting up the card/drive is very vague.

lggomez

Is the 4GB SD card a hard limitation? I tried to flash with a 32GB card with a 4GB FAT partition but without success. Will try to get a card of that size

As for the tools, I really can't verify the process was successful when I prepare the card and I get the following error when trying to flash

mork

Hi, Downloaded the file and extracted to USB thumb drive formatted at Fat32. Ran it through the SD Cardmaker and shorted P5 as directed. It will not recognize the drive. I also noticed that the file you posted is for the DSO5202. Is this the correct version?

SN T 1G/036 001682

Jing

mork replied at 2022-11-17 22:03
No follow up from support on this issue? From my research, the issue is a corrupt firmware issue tha ...

Dear Sir，
Follow the file in the link to reprogram. The file in the link has a deadline, please download it in time.https://www.filemail.com/d/mygokkwowsvhrcw