|
Edited by Gorkde at 2019-8-7 16:22
So I bought the device and it seems Capacity mesurement is way off (measured 70nF for a 100nF and 55uF for a 47uF) but I could not check that with another meter by now.
BUT.....
When using Scope its off definately.
I tested with the AWG 2V and the scope displays over 2V. Tested with 2.25V scope gives me 2.4V to 2.48V (measurement window and scope-line as well as cursor measurement).
Also tested a battery that is 0.76V on my old meter as well as the DMM in the 2D72. In scope mode it has arund 0.825V
Also when shorting the probe it doesn't display zero but around 160-200mV. This changes with the scale I select.
I did calibrate multiple times (without anything connected and after it was running for more than 20 minutes). Always getting the same results!
Do I need to add the probe and shorten it? I don#t think so right?
Also did update the Firmware to the latest. And it had already FPGA V4.
So is my new Hantec defective or not correctly calibrated by the factory? It seems that way.
Btw.... I bought this at aliexpress "Hantek official Store". Is that really your company or yust some seller calling himself that?
|
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
x
|