|
Hello, greetings!I recently purchased a PC USB Oscilloscope device from Hantek, model 6074BD. However, there are some bugs in the equipment when used in DDS (Function Generator) mode. When asking the DDS to generate a frequency of 1Khz, its output always shows half of this value, 500 Hz.
I believe it is a software or firmware problem;Note: I am already using the latest version available on the website V. 2.2.7
Another important detail is that in the equipment manual it refers to a function generator output impedance of 50 ohms. However, when measuring the function generator output it does not present 50 ohms. This implies a voltage error programmed by the software, which instead of showing 3.5 volts peak to peak, shows 7 Volts peak to peak.
To solve this problem, an impedance selection option via software and internal relay in the equipment would be necessary.
That's it for the moment, I would like to know if there is a solution to my problem, any firmware or software update that can solve this problem!
Thanks
|
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
x
|