Wanvesta Publish time 2016-12-17 06:46:41

1008c

hello the vehicle tab is missing from between the utility and windows tab how do i get it

electricmachine Publish time 2016-12-17 08:52:50

Try downloading ver1.0.12 from Hantek's site

Wanvesta Publish time 2016-12-20 05:58:22

electricmachine replied at 2016-12-17 08:52
Try downloading ver1.0.12 from Hantek's site

Hello electricmachine

I will give it a try

Thanks
Wanvesta

electricmachine Publish time 2016-12-20 06:54:36

Hi Wanvesta,
You can access the generator from the vehicle tab too. I haven't worked with it as I had to send my unit back. Am waiting for a new one
Alan

Wanvesta Publish time 2016-12-23 05:32:55

Hi Alan

You say you have had to send yours back.

I am now getting a message on the screen that says scope has stopped working, a problem has caused the program to stop working properly, windows will close the program ...........

If I unplug the USB restart the laptop and reconnect the oscilloscope I get the same message.

When the oscilloscope is unplugged the software works in demo mode.

Is this the same problem has you have had.

Do you think the scope has gone faulty.

Thanks
Wanvesta

amy Publish time 2016-12-23 10:30:40

Sir, please upload a screenshot to study.

electricmachine Publish time 2016-12-23 16:36:07

Edited by electricmachine at 2016-12-23 21:18

Hi, Wanvesta,
I returned it because of the clipping etc - as in my '1008 bugs' thread.
I was going to ask you to check yours, but the new one has the same problem. Inaccuracy at > -15.7v.

First, try uninstalling everything and reinstalling (application and driver)
Check, different ports, power saving etc. Try a different PC?
One way I found to get the software to crash repeatedly was by moving the trigger towards the right hand side.
Everytime I then started the app, it instantly crashed, causing windows to moan and create a report.
Somehow I managed to reset the app. ie It started up in default mode - all 8 channels on, chinese, working.
Good luck
Alan











Wanvesta Publish time 2016-12-24 05:21:45

Hi Alan,
Thanks.

Hi Amy,
I have re installed the software and driver and its working again.

Which do you think the 1008C is most stable on. Software ver 11 which came with it on the disc or ver 12 which I have downloaded from the Hantek site.

Also I include a picture of the rear of the unit. Do they normally have the connection next to the USB I have circled red.
20161223_133158_Ink_LI

Thanks
Wanvesta

Wanvesta Publish time 2016-12-24 05:29:08

Sorry all.
I didn't do the picture properly here it is below.

http://i66.tinypic.com/11id66x.jpg

Thanks
Wanvesta

Wanvesta Publish time 2016-12-24 06:12:15

Hi All again

1008C has stopped working again.

I had it on its waveform generator and I adjusted thetime per division and it stopped working again.

I have uploaded a screen shot as you asked Amy

http://i63.tinypic.com/m7qixd.jpg
Pages: [1] 2
View full version: 1008c