6022BL BAD EEPROM...

apocalips1234

Today i have received a new 6022BL, i have installed without troubles drivers... same with the program, but when activating "P" it doesnt work: device manager show a unknown device with id: USB\VID_04B4&PID_8613, after google search of this driver... and installed the driver: Cypress EZ-USB FX2 (68613) - EEPROM missing so i think is a hardware fault.




P.D: i have tried in 3 diferents pc, and with different usb ca

amy

Sir, please send a message to our support email support@hantek.com

enzo65

I have the same problem, until a few weeks ago it worked fine with saleae software

DavidPMTech

Same Problem:

Amy:

Would you be so kind as to help me?

I have a problem with the Hantek6254BD oscilloscope. The DRIVER does not install -- but the actual scope software does install.

Can you supply the correct driver?

Description:

The PID and Device ID appear to be wrong...

So the Scope software installs -- but the driver does not install. If I change the strings to match -- of course the driver is rejected by windows since it does not match the security string in the CAT file.

My device has:

04B5 and 8613 for the two codes -- not the o4B5 and PI_6CDE
My string in the USB identifier -- read from the SCOPE shows as
USB\VID_04B4&PID_8613

Your software is looking for this code.
[Device]
%VID_04B5&PID_6CDE.DeviceDesc% = Section, USB\VID_04B5&PID_6CDE
;for windows 2000 non intel platforms

amy

Sir, please send a message to our support email support@hantek.com