HandHeld Oscilloscope Software

WisdomAugust

Install and Uninstall


This section describes how to install the handheld oscilloscope software on your computer.

DSO1000S is a software application that provides computer control and data
collection from Hantek handheld oscilloscopes, including the DSO1062S,
DSO1122S, DSO1152S, and DSO1202S product families. Before using
DSO1000S, you need to know the configuration requirements and installation
procedures of the software.

System Requirements
Before using DSO1000S Software, ensure that your computer meets the
following configuration requirements.

Hardware Configuration Requirements
● 1GHz or higher processor
● 200M or more hard disk space
● 1024x768 monitor resolution or above
● 256M or more RAM
● USB or LAN interface and cable

Running Environment
● Microsoft Windows XP, 2000, Win7, 8, 10 (32bit and 64bit)

WisdomAugust

To install handheld oscilloscope, follow these steps:

? Insert the installation disk into the CD-ROM drive.
? Open the install file “DSO1000S” → “Set up” .

? Double click “Setup. Exe” to start the installation wizard. See figure 1.

WisdomAugust

? The Welcome to DSO1000S Setup program dialog box appears.

    See Figure 2.

                                         Figure 2

? Read the information in the dialog box, and click “Next” to pop up the
“Destination Location” dialogue box (See Figure 3).

                                   Figure 3

WisdomAugust

Select the installation folder, click “Next” to accept the default location or click

“Browse” to select other folder ( See Figure 4).

                                      Figure 4

? The Confirm Installation dialog box appears (See figure 5) and click “Next”.

                                        Figure 5

WisdomAugust

? Installing DSO1000S (See Figure 6)

                                                                       Figure 6

After all the files have been installed, the installation complete and click
“Finish”. (See Figure 7)

                                                                        Figure 7

WisdomAugust

If you connect DSO1000S software to the oscilloscope by USB interface,
you need to install USB driver. The USB driver installed auotomatically.

. Connect the oscilloscope (now you should make sure the oscilloscope is
working) to your computer using the included USB cable.

                                         Figure 8

                                          Figure 9

WisdomAugust

Uninstall
After you install the software, you can find “DSO1000S Ver 2.0.0.7” from the
“Programs and Features” in the Microsoft Windows Control Panel and click
“Remove” See figure 10.

                                                               

Figure 10

WisdomAugust

1.2Software Interface

file:///C:\Users\ADMINI~1\AppData\Local\Temp\ksohtml\wps83B1.tmp.pngfile:///C:\Users\ADMINI~1\AppData\Local\Temp\ksohtml\wps83B2.tmp.pngfile:///C:\Users\ADMINI~1\AppData\Local\Temp\ksohtml\wps83B3.tmp.png

1. Menu bar

2. Toolbar

3. Link state indicator

4. Data, graph display area

5. Base Control Panel

6. Status bar

WisdomAugust

1.1.1 Menu Bar

                 Figure 12

File

Figure 13

WisdomAugust

- New

Create a new display windows. Window types include Analyse Bus, Arithmetic, Power Spectrum,

Waveform Measurement, Waveform Tabular, and YT Sheet. (These windows can be created repeatedly).

                     Figure 14