|
Edited by QMESAR at 2018-1-6 22:52
do you have planned releases of the firmware with new functions, for example current measurement (unit) with cc-6x clamps
There are some very stupid things in HANTEK scope software,The support of the HANTEK Current Clamps are in the 1008C scope but in all other scopes the current clamps are not supported ,
This means you can only use the current clamps (showing Current) in the 1008 Scope all the other more expensive scope's you have to calculate the current by hand like in the stone age
Hantek you need a new SW department manager one which live in 2018 not 1940
|
|