|
|
Edited by slaveta@inbox.ru at 2018-2-3 01:17
Same problem on channel DSO-1062b, with any firmware. The second channel works fine. Also when you switch to the multimeter mode (DMM), all the time in the measurement mode voltage. Switch to measure capacitance, diode, current, continuity nothing. The bottom line appear selectable modes, responds to keystrokes, confirms with an audible signal and the upper terminals to the voltage measurement (V) does not change, and did not measure any voltage,any capacity, no resistance,no current. When self-calibration (self calibration) after 25 test I get an error 0x502.
|
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
x
|
Author
Post time 2018-2-3 01:10:53
Post time 2018-2-3 15:53:51