|
|
Hello, just new to this device I try to measure a 1MHz pulse signal.
The settings are 2us/div 48MHz sampling, single shot rising edge 50mV level.
Somtimes I see nearly 4 pulses:
The trigger point seems to be not on the screen at all, I see it when increasing the pulse distance.
Only the first negative pulse on the plot keeps it's position.
The positive Edge triggered is left of the screen and I am not able to see any pretrigger data!
Is this a known bug?
If this device should be useful for unknown signals I strongly recommend to show the trigger point in the plot! For the HW it would be better if a delay in the data path compensates the delay of the trigger unit.
Any further suggestions?
Regards, Andreas
|
|
Post time 2017-8-17 17:11:28
Favorites
Shares
Collection
Author