Hantek 6074BC EEprom problem

temeraire · Post time 2017-1-16 06:06:37

I need some help with this oscilloscope which seems to have corrupted eeprom(24LC64) attached to Cypress microcontroller. I have replaced it but I still need firmware for this chip, is there anyone who could help?

temeraire · Post time 2017-1-21 17:30:43

Oscilloscope works great now, thank you amy for help

Reni · Post time 2023-6-16 17:15:09

Edited by Reni at 2023-6-17 05:34

Hello. I have a problem connecting a Hantek 6074BC oscilloscope. The computer does not recognize the device. Gives an error "code 43". VID/PID not defined correctly. Please send me an EEPROM dump (24LC64). My e-mail: proaviaotor@gmail.com

ercoupeflyer · Post time 2022-11-8 13:23:41

Hi I have the same problem can you help me?

mackenzieelectric@gmail.com · Post time 2022-11-8 07:35:24

What did you re flash with? I have the same issue. Can you help me?

wangshuang · Post time 2022-2-11 08:33:47

Zsarhmeg replied at 2022-1-25 16:57
Hi
I bought a hantek 6074be a couple of months ago. I installed software on my own workshop sheet. I ...

what does it show in device manager?

Zsarhmeg · Post time 2022-1-25 16:57:44

Hi
I bought a hantek 6074be a couple of months ago. I installed software on my own workshop sheet. It worked well ... But I'm in trouble now. The software will no longer start until the hantek is connected to usb. If I disconnect the hantek from the usb, the software will start. If I connect the usb after starting the software, it will not connect. Think this is a firmware problem ?!
It appears to have violated the eeprom connected to the microcontroller (24LC64). It no longer recognizes USB. can anyone help me

Please help !

rtr989 · Post time 2020-11-23 20:50:10

Edited by rtr989 at 2020-11-23 21:39

.............

amy · Post time 2017-10-25 14:23:43

alpsoid74 replied at 2017-10-25 13:53
drivers for the oscilloscope are not installed.
The system is defined as "Cypress FX2LP No EEPROM De ...

Please send a message to me caiyijun@hantek.com

alpsoid74 · Post time 2017-10-25 13:53:00

Edited by alpsoid74 at 2017-10-25 14:18

drivers for the oscilloscope are not installed.
The system is defined as "Cypress FX2LP No EEPROM Device". Probably need EEPROM firmware. I would really appreciate it if you send it to me.

amy · Post time 2017-10-25 09:01:22

alpsoid74 replied at 2017-10-25 01:21
Hello. I need a dump to restore the Hantek6074BD program RestoreIIC.exe

Sir, sorry, I can't understand what you mean.

Hantek 6074BC EEprom problem

This post contains more resources

This post contains more resources