DSO3064 VII won't read more than one channel at a time

tahotoy · Post time 2016-9-14 06:50:17

I have the 4ch 3064, hooked up all 4 channels to spark plug induction adapters and only ch1 showed a signature. I tested all four pickups on ch1 and they check out. At the time of testing I found that I could get a signature on one channel at a time which defeats the purpose of comparing injector, ignition etc signatures on the fly. Is it safe to connect all four channels to the oscilator test out simultaneously?I hope someone can shed some light on this.

Thanks in advance,
Pete

tahotoy · Post time 2016-11-2 06:55:57

Bear with me, I'm coming back with some info. Thanks

tahotoy · Post time 2016-10-14 10:56:27

Software is updated and it is far more stable. I didn't have enough time to duplicate the four channel test but I'll update asap with more details. Thanks

amy · Post time 2016-10-11 16:34:07

Sir, sorry to inform that there is no a update for DSO3064 firmware.

tahotoy · Post time 2016-10-11 12:31:39

Thank you, I downloaded all the software and will run the same tests again. Is there a firmware update for the 3064?

amy · Post time 2016-10-11 09:47:35

Edited by amy at 2016-10-11 09:48

Sir, please download the DSO3064 software in the link: http://hantek.com/en/ProductDetail_2_128.html

tahotoy · Post time 2016-10-11 07:24:26

I cannot find a firmware update to go along with the application. Is there one? Thanks

amy · Post time 2016-10-9 09:09:07

Sir, please register a username and download the DSO3064 software to use on our official website: http://hantek.com/en/ProductDetail_2_128.html

tahotoy · Post time 2016-10-9 03:33:52

No changes, the wave form gets tall and dirty like this then crashes

tahotoy · Post time 2016-10-9 03:32:19

no invert on ch 1

DSO3064 VII won't read more than one channel at a time

This post contains more resources

This post contains more resources

This post contains more resources