DSO 8060 Output Arbitrary Waveform Steps

WisdomAugust

1. Turn on DSO8060.
2. Switch DSO to signal source status.
3. Connect DSO to PC by a USB cable.
4. Open the software on PC.
5. Click  in the menu to open a signal source operation window. See below picture.



6. Press in the toolbar of signal source window to open following device option window.



7. Select the device you want to open and click “OK”.
8. Click   in the signal source window toolbar to connect DSO to PC.
9. Click  in toolboor to enter into the arbitrary waveform edition interface.
10. Zoom in/out the editable waveforms by clicking   button.
11. Dragging the editable waveforms by press mouse left constantly.



12. Output the signals to other oscilloscope by a BNC connecting cable, and you can observe the same waveforms on the other oscilloscope.