Latest firmware for MSO5074FG?

logical

Hi,

I've just updated the firmware too and have trigger problems too.

- Connecting the CHx probe to the test output connector
- Adjusting 2V/div
- Set trigger level somewhere between
- Trigger: Edge, CHx,, DC Coupling
If you now change the vertical position upwards above the trigger level the triggering stops.
Seems you don’t calculate the trigger level correctly with the vertical position.

And by the way: I am still not happy with exemining a single shot measurement.
I expect to be able to zoom/shift the view of the captured data, but this now seems only to work with the normal (oscilloscope) mode - the other modes are having problems (don't shift/zoom od loss of data view)

logical

Any news here ? I am concerned about the Hantek update strategy and the will to fix bugs in their products. The "little deviation" is not so little, it is nearly unusable. When can we get a working firmware here ?

logical

logical replied at 2018-3-21 15:31
Any news here ? I am concerned about the Hantek update strategy and the will to fix bugs in their pr ...

Still no update available? I don't understand HANTEK here - this "little deviation" makes it nearly unusable as described below (these settings are for 3.3V measurements more as appropriate.
So no update for more than 2 years.
My opinion: This product is dead. Forget HANTEK

(@Hantek: an update with these fixed bugs could change my mind, but for me it seems you behave like a typical asian company - build with poor quality and no responsibility on fixing SW issues. Sorry for these words)