Well, in anticipation of the long awaited bug fixing I want to clarify a couple of points.
2. When the base time is less than or equal to 80ns, the scope enters into interpolation mode. Most of the points are drawn by the interpolation method based on the collected points.
Look at the following screenshots:
Here you can see the same point at a different time scans. Waveforms in both channels were taken from one point of the circuit, that is, should be identical. I wonder why, when the set scan time 4ns, the waveform on the second channel is drawn wavy line? Why is there such a big difference in the interpolation of the waveform? Another question: why the waveform received on both channels are shifted relative to each other at 5 ns? This is normal?
Author
