|
Edited by Oleg10011001 at 2016-8-30 10:39
Unfortunately, I did not understand your response, and I suspect that you do not understand my question. I'm not talking about the recording mode. I'm talking about an ordinary oscilloscope mode. I became necessary to observe the slow but lengthy process. I want to on the screen very slowly draws the curve of the waveform, so that I could observe the waveform on the screen to draw 24 hours (setting a scan time 1-2 hour per grid). For example I want to see the curve of voltage drop on the battery discharge when it is slow. Theoretically my oscilloscope is quite capable; if you use a lot of memory (2M) lower sampling rate (10S / s or less), you can get the waveform of a long process, but in practice some reason I can not do that - the minimum sample rate is 1250Ks / s and below does not fall (when using 2M memory).
|
|