DSO5000 Series Quick Start Guide

WisdomAugust

WisdomAugust

6. Press Mode and continue pressing the softkey to select the sweep to trigger on:

? Auto Cause the oscilloscope to sweep, even without a trigger.

? Normal The oscilloscope only sweeps if the input signal reaches the set trigger point; otherwise the screen is frozen on the last acquired waveform.

7. Press Overtime and turn the Multifunction Knob to adjust the overtime to trigger on. The range available is from 20 ns to 10 s.

8. Press Coupling and continue pressing the softkey to select the components of the trigger signal applied to the trigger circuitry:

? AC  Blocks DC components and attenuates signals below 10Hz.

? DC  Passes all components of the signal.

? Noise Reject  Eliminating noise from the trigger signal to prevent false triggering.

? HF Reject  Attenuates the high-frequency components above 80kHz.

? LF Reject  Blocks DC components and attenuates the low-frequency components below 8kHz.

WisdomAugust

7. Press Overtime and turn the Multifunction Knob to adjust the overtime to trigger on. The range available is from 20 ns to 10 s.

8. Press Coupling and continue pressing the softkey to select the components of the trigger signal applied to the trigger circuitry:

? AC  Blocks DC components and attenuates signals below 10Hz.

? DC  Passes all components of the signal.

? Noise Reject  Eliminating noise from the trigger signal to prevent false triggering.

? HF Reject  Attenuates the high-frequency components above 80kHz.

? LF Reject  Blocks DC components and attenuates the low-frequency components below 8kHz.

WisdomAugust

5.2.6  To set up alternate triggers

The Alternate trigger mode splits the display horizontally and lets you trigger on two, non- synchronized signals.

1. Press TRIG MENU.

2. In the Trigger menu, press Type.

3. Continue pressing the Type softkey to select “Alternate”.

4. Press Select to select the channel to set up triggering on, either “CH1” or “CH2”.

At this point, the remaining items in the Trigger menu let you set up independent triggers for the selected channel.

For each source, you can set up edge, video, pulse width, or overtime triggering.

You can also specify other trigger setup options, except trigger sweep.

WisdomAugust

WisdomAugust

5.2.7  To specify a trigger holdoff

Trigger holdoff can be used to stabilize a waveform. The holdoff time is the oscilloscope's waiting period before starting a new trigger. The oscilloscope will not trigger until the holdoff time has expired.

WisdomAugust

5.2.8  Using the External Trigger Input

You can trigger on external inputs by selecting “EXT” or “EXT/5” (5:1 attenuated) as the trigger source in all trigger modes except Overtime and Alternate.