I just upgraded firmware to Oct 2022 and found a problem with f() generator.
If I set to any, like sine, square, ramp, accept defaults for ampliftude, freq (was 1 Khz), offset
0, the generator will only start if I turn on modulation. If I dont want modulation I turn that
off and then waveform turns on as desired. If I leave modulation opn waveform does not start.
So in brief, in order to get waveform to start I have to turn on then off modulation.
Post time 2023-6-12 09:13:47
Favorites
Shares
Collection