Single Output DC Power Supply HDP135V6 Series Guide

WisdomAugust

Safety Instruction

Read the following general safety precautions before any operation to insure your safety and to keep the best condition

for the DC power supply. These precautions must be followed when operating, storing, and repairing the DC power supply.

Safety Guidelines

Warning

? Verify that the DC power supply is set to match the available line voltage and that the correct fuse is installed.

? Connect the protective grounding conductor of the AC power cord to an earth ground to avoid electrical shock.

? Do not disassemble the device unless you are qualified as service personnel.

? Do not operate the device in an explosive atmosphere, or wet environments.

? Avoid severe impacts or rough handling that leads to damaging the device.

? Turn off the device before connecting to the output terminals.

? Be careful when dealing with output voltage above 60VDC.

? Do not block or obstruct the cooling fan vent opening.

? Don not operate damaged or defective devices.

? Do not discharge static electricity to the device.

Caution

? Disconnect the power cord before cleaning.

? Clean the outside of the device with a slightly dampened cloth.

? Do not use detergent, volatile liquids, or chemical solvents.

? Do not spray any liquid.

WisdomAugust

WisdomAugust

WisdomAugust

Introduction

Features

l Single channel

l Quiet operation

l Safety interlock

l Power up to 210W

l 10mV/1mA resolution

l Up to 6A or 35V output

l Memory for up to 10 setups

l Low output ripple and noise

l Individual knobs for voltage and current

l With 5-12V output quick charging USB interface

l Computer control via RS232, programmable (HDP135V6S only)

l LED display to indicate 4 digits voltage and current simultaneously

l Over voltage, over current, over temperature, and short circuit protection

Package contents list

Inspect the following standard shipped items of the HDP135V6 series DC power supply.

l 1pc Power Supply

l 1pc Power Cord

l 1pair Power Test Leads

l 1pc Certificate of Conformity

WisdomAugust

WisdomAugust

WisdomAugust

WisdomAugust

WisdomAugust

WisdomAugust

Setup the instrument

Place the power supply's feet on a flat horizontal surface. Connect output leads to the front panel,

being careful not to short the leads together. Attach the power cord to the rear panel, then plug it into the main power.

Connect RS232 cable as desired, and you may also secure the power supply with a security lock cable.

Before disconnecting cables and cords from the power supply, turn the power supply off using the rear-panel power

switch and disconnect from the supply source by unplugging the detachable power cord.