|
I emailed the following questions on November 28, 2021. There has been no action by Hantek to date.
Can Hnatek please reply?
From: [url=]eurorally@aol.com[/url]
To: [url=]info@tams-tech.com[/url]
Cc: [url=]EurorallyOL@aol.com[/url]
Sent: 11/28/2021 2:25:14 PM Eastern Standard Time
Subject: Hantek 1008c
Ladies and Gentlemen:
I purchased Hantek 1008c, feeling my way through using it and
I spent the whole day on it today.
My version includes a probe with a wire clamp and Hantek HT-25
on it.
Some of your pre-programmed patterns for wave pattern measuring
say in the left bottom corner in red letters "Probe connected to CH 1
via attenuator 20:1" and some do not say anything about the attenuator,
just say "Probe connected to CH1."
QUESTIONS:
1. Do I need to buy the 20:1 attenuator and if so, for which measurements
or, is that taken care by Hantek HT-25 on the (new?) probe with the wire
clamp?
2. Do I need to buy Hantek CC 65 (65 Amps) and / or Hantek CC 650
(650 Amps) for certain measurements and if so, for which ones?
3. Where do I find a complete description how to connect Hantek 1008c
with the wire clamp and Hantek HT-25 on it for various kinds of
measurements envisioned in your pre-programmed wave patters?
4. Is the wire clamp with Hantek HT-25 and the eight probes with red and
black alligator clips all that is required for any kind of measurements?
Thank you,
Ivan Orisek
|
|