Buttons and knobs no respond on 2D10

wangshuang

Customer consultation


hello, my hantek DSO2D10 does not respond to physical buttons. I can change parameters with PC software, but not with physical knobs and buttons. I restart the factory settings device with pc console command. but it didn't help. all leds on knobs and buttons are on, and i hear beeping when pressing buttons, but no response from oscilloscope.
What should I do to fix the device?


Reply


Please try to reconnect the cable between the mainboard and the keyboard.

Jing

sjoeaat1 replied at 2022-2-19 23:16
Since yesterday I have exactly the same problem with my DSO2D10.

Please email me at support@hantek.com.and provide your related videos.

sjoeaat1

Since yesterday I have exactly the same problem with my DSO2D10.

wangshuang

Kjadr2 replied at 2022-1-30 04:36
Since none of the buttons work, I can't access the Utility menu. Here is a link to a video of what ...

Please email me the serial number. wangshuang@hantek.com

Kjadr2

wangshuang replied at 2022-1-10 15:25
Please perform "FrontPanelSelfTest"(In Utility), better to give a video.

Since none of the buttons work, I can't access the Utility menu. Here is a link to a video of what is happening: https://1drv.ms/v/s!AsOCDTRBcITBh_pH7dHzKm1QCypYVA

wangshuang

Kjadr2 replied at 2022-1-8 11:12
I have a similar problem. I have a DSO2D10 which is less than 3 months old. After not using it for a ...

Please perform "FrontPanelSelfTest"(In Utility), better to give a video.

Kjadr2

I have a similar problem. I have a DSO2D10 which is less than 3 months old. After not using it for a few weeks, I turned it on and it boots up, but none of the buttons work. The "CH2 MENU" button and "RUN/STOP" buttons are green and the rest are off. All of the buttons will beep, but nothing happens. Channel 2, which is lit, will not show a signal when a probe is connected to it.  HELP!!!

Spown_1

I have the same problem with my DSO8202E. I can switch ON/OFF but the screen still frezen.  I sent an email to support but no response . Any  help?  Thanks

wangshuang

thomas-fish replied at 2021-12-27 01:03
Am facing same issue: no response from physical button - though did not try yet connect to PC and tr ...

Please email me, wangshuang@hantek.com

thomas-fish

Am facing same issue: no response from physical button - though did not try yet connect to PC and try to set back system (how does this work?)

The scope boots up and initializes hardware. After that it seems to load last settings and gets stucked directly. Pressing the physical button only creates a "beep" but nothing reacting on screen nor possible to switch off e.g. AWG.

Am not able to work with the DSO currently...