Please select To the mobile version | Continue to access the desktop computer version

Electronic Engineer Discuss

View: 4035|Reply: 0

2D42: the scope TRIG again after STOP

[Copy link]

1

Threads

13

Posts

13

Credits

新手上路

Rank: 1

Credits
13
Post time 2021-8-22 23:39:23 | Show all posts |Read mode
When I set the scope in NORMAL trig and I capture a signal, then I press STOP (red button), if a new signal arrives the scope trigs again losting the stopped trace (error).
This behavior is always repeated only one time after the STOP... why?

While in SINGLE mode, after the scope captures a signal it STOP and any other new signal cannot retrigger the scope (right).

Another thing is:
If I set the scope in NORMAL trig and no signal is present, the scope says "WAIT" on the top left corner. Now I decide to press stop (whitout any signal) the scope says "STOP" red.
If a signal arrives the scope captures it even if "stopped".

It seems that the trigger is running always even the capture is stopped!

Why these stranges behaviors?
It is possible a workarround?
Thank you, Carlos.



Reply

Use magic Report

You have to log in before you can reply Login | Register

Points Rules

Dark room|Mobile|Archiver|Electronic Engineer Discuss

2024-3-29 01:47 GMT+8 , Processed in 0.204098 second(s), 21 queries .

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

Quick Reply To Top Return to the list