hantek6022BL

kutsal33 · Post time 2021-8-16 23:23:31

oscilloscope cannot be switched on; no led is lit.

amy · Post time 2021-9-13 17:00:15

Sorry, we have no better way. It is recommended to contact your seller for return to the factory for repair.

kutsal33 · Post time 2021-9-12 12:11:03

Wenn the oscilloscope is connected to the computer,the LED light is NOT ON and not flashes red!these is maybe My problem!thanks.what can i to do?

amy · Post time 2021-9-2 11:48:59

Please change the USB cable or computer to try.
If the problem still cannot be solved, please contact the seller to repair it.

kutsal33 · Post time 2021-8-31 14:17:12

there is not a short circuit between any two of these four pins''(There are some resistance values between 920 ohms and even higher ohm value'') ..I hope that with your help we will find a solution.thanks

amy · Post time 2021-8-31 09:04:18

Please test whether there is a short circuit between any two of these four pins.

kutsal33 · Post time 2021-8-30 00:10:58

5v and 3,3v are ok.the resistance between the two ends of C29 is 318 ohm.

amy · Post time 2021-8-27 08:46:42

Edited by amy at 2021-8-27 08:48

1. Please test whether the resistances of 5V point and 3.3V point to ground are short-circuited.
2. If so, remove D1 and L29, and test whether the resistances of 5V point and 3.3V point to ground are not short-circuited. And then test whether the resistance between the two ends of C29 is short-circuited.
3. If so, the chip U2 should be fault. The model of U2 is CY7C68013A-100AXC. You can try to purchase it on eBay.

kutsal33 · Post time 2021-8-25 22:44:00

no,in device manager no, when I connect the device, nothing happens,nothing discovered such as unknown device.thanks.

kutsal33 · Post time 2021-8-25 21:57:48

no,no, when I connect the device, nothing happens in device manager such as unknown device

hantek6022BL

This post contains more resources

This post contains more resources