6254BD SPI Decoder

QMESAR · Post time 2021-6-23 13:19:58

Edited by QMESAR at 2021-6-23 13:24

Dear Amy
Please see screen prints
Question why is the Trigger always on the SCL line I cannot select the trigger on SDA ,if you change the trigger from edge to SPI it auto select the SCL line ?I send photos by email I canot get them to upload
Thank you

amy · Post time 2021-6-23 08:27:33

Please provide the product information to study.
"Help->About"

QMESAR · Post time 2021-6-21 13:15:25

Edited by QMESAR at 2021-6-21 13:17

Hi Team

I have now tried everything with the decoder SW it not working correctly .
I have set the triggers to SDA (CH1) and CH2 on SCL and also changed it around this Trigger on SCL(CH2 ) and SDA on (CH1) it always show on the Screen the strange binary values and in the Table view the wrong hex value.
As you will see from the above screen prints the signal itself is correct the Rigol decoder decode correctly and the Hantek decode decode wrongly ,

Can you please assist to get this working I am in the middle of a SPI project for a customer .

6254BD SPI Decoder

Viewed forums