6254BD SPI Decoder

QMESAR

Dear Hantek Team,
Can you please help me with a document how to use the SPI and I2C Proptocol decoders
I could not find any information in the help file.

If I use my bench Scope with it SPI Decoder it is working prefectly as shown in PIC1
You decoder show some silly binary numbers that make no sense ,

How do I set the decoding to show Hex and the table view also does not show any data when a single capture is done and in Normal mode it shows the incorrced values and as I said I know
what the Hex values should be as I programmed my micro ou output  0xB7 and 0xBB which it does but the Hantek decoder shows some value



Hope to get some sort of help on this
Thank you
QMESAR

QMESAR

Dear Amy.

Thank you to you and the HANTEK team the SPI decoder is working fine now

Should I test the UART and IIC or do you know if your team has tested this also ??

Thank you so much again

QMESAR

Hi Amy.

It may be that the power supply of the computer USB port is unstable and the code is lost. It is recommended to connect the red end of the USB cable to a 5V@2A power adapter.

This makes absolute sense
Thank you for the information I will instruct our people to make sure they use the scope correctly powered  ,Also many thanks for the new software much appreciated

Regards

amy

It may be that the power supply of the computer USB port is unstable and the code is lost. It is recommended to connect the red end of the USB cable to a 5V@2A power adapter.
And the new software:

QMESAR

Dear Amy.


Thank you very much, you helped me so much the scope is working as before ,Thank you so much I appreciate your help and support

Question why did it loose the EEPROM Code will this happen again ? if we use it for long period of time like 4 Hour testing periods ?

      

amy

Yes. The driver files are in CyConsole folder.

QMESAR

Dear Amy .
Thank you for document and files.

I am not sure what must I do here ,
must I right click and install the win 10 drivers ?

amy

Please refer to the attachment to operate.

QMESAR

Dear Amy
  
Thank you for your asistance much appreciated.
the screen print as requested.

amy

Please check the PID/VID.


Please connect the scope to your computer and right click the unknown device in device manager, select Properties.

And give me a screenshot of the Hardware ID as the following picture.