Hantek 6254BE - CCD(+) Signal Wave Form Issues

cloves

Hi I have a Hantek 6254BE,

I am currently probing the CCD (Chrysler Collision Detection), I am unable to get the square wave form compressed down in size so I can see it better. I have tried all the settings in both dials.

I am running software HT6004BX_Software and even tried 2.2.6. Screen shot shows version 2.2.5. I am using the Hantek HT30A cable to back probe wire.

Am I running the correct software? Why can't I see the signal correctly?



https://www.eediscuss.com/forum.php?mod=attachment&aid=NDMwNXxhZjJiOGI4M2UwOTc3MjU4MGYzMGE1ZGJjMGIyZDAyMXwxNzEzNTczNDc3&request=yes&_f=.png

cloves

Reading up on CCD (Chrysler Collision Detection), you have to use 1 DDS probe lead to (+) and other to the (-) in order to see the wave form.

Would still like to be able to check each signal square form to make sure they are mirroring each other. Should behave like CAN system.  CCD data bus system was designed to run at a 7812.5 baud rate.