Edited by amy at 2020-12-18 14:18
1. Download the software in this link and install:
2. Open the scope and connect it to your computer, run the software, click "Help->Checkupdate" to open the update interface.
3. Click “Start” to start update. update as prompted.
4. The content indicated in the figure below is not displayed completely, please refer to this, "Turn off the oscilloscope, press F1 and hold, then press the power button until the RUN/STOP light flashes red and green, release all the buttons, and the device will start to upgrade."
After update, the scope will start automatically.
|