Update Firmware by software for Hantek2000 Handheld Oscilloscope

amy

1. Download the software in this link and install:

https://e.hantek.com/Products/Hantek2000

2. Open the scope and connect it to your computer, run the software, click "Help->Checkupdate" to open the update interface.

3. Click “Start” to start update. update as prompted.

4. The content indicated in the figure below is not displayed completely, please refer to this, "Turn off the oscilloscope, press F1 and hold, then press the power button until the RUN/STOP light flashes red and green, release all the buttons, and the device will start to upgrade."

After update, the scope will start automatically.

QMESAR

Hi Amy
This  update just broke my 3 day old scope ,
I followed your instructions
(1) the button flashed once green red I released it the software did something and then afterwards I have only run stop button constantly ON RED se below
How Can I recover the instrument

QMESAR

Hi Amy ,

I recovered it by downloading the dfu file and then upgraded

李继春

QMESAR replied at 2020-12-18 19:23
Hi Amy ,

I recovered it by downloading the dfu file and then upgraded

艾米汉泰2000当中的2D72最新固件是多少版本呀？