|
Is there a SCPI command to toggle Run / Stop mode or to produce a single trigger on a DSO4254C (DSO4004 series) oscilloscope?
I have tried "TRIGger:FORCe", "TRIGger:MODE", "*TRG", "TRIGger:STATus". None has worked.
I have already downloaded and search the SCPI Commands document (DSO4000BC_SCPI_EN.pdf) from http://www.hantek.com/products/detail/12167
I couldn't find any command that seems to perform the run/stop/single trigger function.
I am controlling the osciloscope from Matlab and most of the documented commands from the above document work as expected.
Thanks in advance
|
|