Be careful as I performed the FPGA upgrade and it bricked my 6204BC.
Tried many things but still will not go.
Recognized as the correct device but front light and SW will not go when it is connected.
I'm using up to date Windows 10 pro.
Qmesar.. did you have the latest Hantek SW install when you ran the DSOUpdate? It never completes when I run it. Waited over an hour...
I had the latest PC SW 2.2.6 installed as I have been trying to get the decode function for sometime. When I saw a firmware release to fix this issue (I had the old original/as shipped FPGA FW), I asked Hantek if it was compatable, 'Yes' was the answer. But the procedure bricked it. Unfortunately after much correspondance there appears to be no field solution and I may have to ship it back to the factory. I was hoping that someone may have experienced similar and fixed it in the field. Living in hope. Cheers.
Post time 2020-9-27 07:32:01