DSO5102P damage

4340 · Post time 2020-8-22 06:41:26

Hello.
Channel 1 on my scope was damaged by an over-voltage input. No signal gets through on channel 1. Channel 2 is ok. Can I buy a new circuit board? The scope is less than a year old and used very little so I'd like to fix it.
Thanks

4340 · Post time 2020-8-23 07:05:56

Nevermind. I've been told there is no after-purchase support offered by Hantek.

wangshuang · Post time 2020-8-24 13:41:33

4340 replied at 2020-8-23 07:05
Nevermind. I've been told there is no after-purchase support offered by Hantek.

Sorry, the day before yesterday was the weekend, so we did not reply in time.
Please contact the seller to buy a new circuit board.