Hantek DSO1060 after rolling back the firmware does not load

Krot · Post time 2020-8-10 22:19:29

Hello, please help, while my oscilloscope Hantek DSO1060 has been rolled back firmware, on the screen appeared the message "ROLL BACK" with the progress bar on the oscilloscope worked fine after I turned it off and then turned on the oscilloscope can not boot, now when you button it emits a beep and turns off 5 seconds, for repair need a flash memory dump.

Krot · Post time 2020-8-16 23:07:02

To repair it you need to flash the flash memory dump (SST39VF3201),I need a binary file firmware dump, I'll flash it into memory and my oscilloscope will work.

Krot · Post time 2020-8-18 22:27:36

Hello, I answered your email

Krot · Post time 2020-8-27 00:45:19

You misunderstood me, the oscilloscope does not load, I need a dump of the flash memory chip (SST39VF3201), and what you sent me is a file for updating via USB flash drive, I have the same as here https://www.eediscuss.com/forum. ... &extra=page%3D1 only the oscilloscope model is different.

Krot · Post time 2020-10-31 22:05:23

The problem is not solved, you need a flash dump SST39VF3201

Krot · Post time 2020-12-10 17:06:26

The problem is not solved, you need a flash dump SST39VF3201