|
Hi,
I have a quite new HANTEK 6254BD USB oscilloscope. I was testing the accompanied software a lot and it seems that I stopped the calibration in progress.
Now I have no chance to calibrate channel 1. For channels 2 to 4, it tries to find min. and max. values for the different ranges. For channel 1, the signal is jumping up and down and never gets stable. Therefore, I assume, the process cannot resume since the software is waiting for a stable signal.
I tried to factory reset it, switched it on/off, .. still no chance. Now I cannot use channel 1 at all!
How can I set the calibration to default? It there another way to "hard reset" it?
thanks,
Berni
|
|