Trig Menu Key -> Type -> UART/LIN/CAN -> Source Softkey help information Press this softkey and turn the V0 knob to select the trigger source from analog or digital channels input.
Trig Menu Key -> Type -> UART/LIN/CAN/SPI/IIC -> Baud Rate Softkey help information This softkey selects a baud rate of data transmission to match the signal in the device under test. If the desired baud rate is not listed, select User Defined.
Trig Menu Key -> Type -> UART/LIN/CAN/SPI/IIC -> User Baud Softkey help information When User Defined selected on the Baud Rate softkey, press User Baud softkey and turn the V0 knob to set the desired baud rate at a small step of 1 bps.
Trig Menu Key -> Type -> UART -> When Softkey help information Press this softkey to select the desired trigger condition. * Start - the scope triggers on the start frame position. * Stop - the scope triggers on the stop frame position. The trigger will occur on the first stop bit whether the device under test uses 1, 1.5, or 2 stop bits. * Data - triggers on the last bit of the specified data bits. * Parity Error - triggers on a parity error based on the preset parity on the Parity softkey. * Error - triggers when an error occurs by checking the start bit and stop bit.
|