For example, set the label to " Hantek-1". In the virtual keypad, rotate the V0 knob to select "Caps" and press down the knob to switch the uppercase or lowercase mode. Rotate the V0 knob and select "H", press down the knob. Then, in the input selection area, rotate the V0 knob and select "a". Press down the knob to input "a". Use the same method to input "ntek-1". Press Enter to compete the editing. You can also enable the touch screen to operate by touch gestures. If Display is enabled, the label “Hantek-1” will be displayed at the left of CH1 waveform. To delete or modify the input characters, rotate the V0 knob or enable the touch screen to realize it. * Rotate the V0 knob - use the Delete key or Clear key to delete or modify the characters. To modify the characters, input the desired characters again. * Enable the touch screen - use the touch gestures to directly move the cursor to the right side of the character required to be deleted or modified, and then tap the Delete key or Clear key to delete the character. To modify the characters, input the desired character again or delete the character.
|