Set as Homepage Add to Favorites

Enable Auxiliary Access Narrow screen

Electronic Engineer Discuss»Forum › (Oscilloscope)示波器 › Automotive Oscilloscope › Hantek HT25 COP probe setting in software

New

View: 7123|Reply: 3

Print

Prev. thread

Next thread

Hantek HT25 COP probe setting in software

1 Threads	3 Posts	3 Credits

Rank: 1

Credits: 3

Send PM

Go to Page No.

Jump to specified page

1^#

Post time 2020-6-8 18:44:10 | Show all posts Reply Awards

Reply Awards

|Descending |Read mode

There is no HT25 COP probe setting in the 1000C software that i have, also do you use an attenuator with the probe or is it built into the probe?

Favorites0 Shares Collection0

Reply

Use magic Report

1 Threads	3 Posts	3 Credits

Rank: 1

Credits: 3

Send PM

2^#

Author| Post time 2020-6-10 20:54:23 | Show all posts

wangshuang replied at 2020-6-9 15:48
The attenuation ratio of HT25 is 10000:1, just select X10000 in the software.

Thank you for the reply, are there any videos on using the COP probe?

Reply Support Not support

Use magic Report

New

Dark room|Mobile|Archiver|Electronic Engineer Discuss

2024-5-5 20:21 GMT+8 , Processed in 0.155507 second(s), 20 queries .

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

Quick Reply To Top Return to the list