Hantek HT25 COP probe setting in software

mazzerman

There is no HT25 COP probe setting in the 1000C software that i have, also do you use an attenuator with the probe or is it built into the probe?

wangshuang

The attenuation ratio of HT25 is 10000:1, just select X10000 in the software.

mazzerman

wangshuang replied at 2020-6-9 15:48
The attenuation ratio of HT25 is 10000:1, just select X10000 in the software.

Thank you for the reply, are there any videos on using the COP probe?

wangshuang

You can refer to the picture in Hantek website,
http://hantek.com/ProductDetail_18_6229.html
or view on this link:
https://www.iqiyi.com/w_19rssgnkf1.html