Hantek6254BC IIC (I2C) decoding

Matti

Hantek6254BC, how do I get the IIC (I2C) message decoding to work?
Software Version: 20160528
Driver Version: 20160531
FPGA Version: D001
PCB Version: V1.08
Product SN: 64C08135

QMESAR

Hi Team
Any update on this !

Regards

wangshuang

QMESAR replied at 2020-7-24 00:11
Please be so kind and inform us on this thread when you have modified the Software that the Seria ...

ok, I will.

QMESAR

It should be a bug. I will report it to the engineer for modification.

Please be so kind and inform us on this thread when you have modified the Software that the Serial decoders are also shown in the main trigger window

Thank you very much

QMESAR

Hi Guys ,

A big thank you to both of you, I found it and  happy this was something that was always missing in the HANTEK scopes now it is there
Great Stuff

wangshuang

KeenAmateur replied at 2020-7-22 17:27
Hi

The trigger for serial decoding only appears on the RHS of display in trigger node, trigger drop ...

You can directly select the decoding function in the list above. The decoding function was added later and did not appear in the trigger setup. It should be a bug. I will report it to the engineer for modification. Currently you can use it normally.

KeenAmateur

Hi

The trigger for serial decoding only appears on the RHS of display in trigger node, trigger drop down, it does not appear in drop down menu options. See picture.
Hope this helps.

QMESAR

Hi.

I did install the latest version of the SW before I did the upgrade ,I just did a new download from your link and installed the SW again No IIC option

Please help Thank you
  

wangshuang

QMESAR replied at 2020-7-21 15:34
I would expect the I2C to be under the Trigger setup but with me there is nothing,
I have successful ...

Please download the latest software to try again.
http://hantek.com.cn/products/detail/10164

QMESAR

I would expect the I2C to be under the Trigger setup but with me there is nothing,
I have successfully done the FPGA upgrade