How to do mainboard programming via USB?

WisdomAugust · Post time 2020-4-15 08:54:46

Install and configure tool SecureCRT

Unzip “SecureCRT.rar” in the file.

Double click “SecureCRT.exe”

Click “OK”.

WisdomAugust · Post time 2020-6-11 09:27:31

Select wh5 root_dso5102p3.ubi

2.6 Power off and restart the device

WisdomAugust · Post time 2020-6-10 09:10:00

2.5.4 Downloadwh5 root_dso5102p3.ubi

Select “5”, click “enter”

WisdomAugust · Post time 2020-6-9 08:08:09

Open EmbedSkyDownLoadTool, select USB->UBOOT->select file

Select wh3 zImage_5102P3

Then review software SecureCRT

When this statement “Enter your selection: ” appears, that means wh3 zImage_5102P3 programming is finished.

WisdomAugust · Post time 2020-6-8 08:30:49

2.5.3 Download wh3 zImage_5102P3 into mainboard

After installing the driver successfully, tap “3”, click “enter”

WisdomAugust · Post time 2020-6-6 08:08:08

2.5.2 Install USB download driver

Restart it and import several “blank” fastly and immediately, the interface would be shown as below.

Tap “2”, the unknown device will be found and waiting to be installed.

Select the USB Download Driver folder to install the driver.

WisdomAugust · Post time 2020-6-5 08:20:18

Connect your scope(J801) to PC serial interface via RS232 to TTL module or USB to TTL module.

WisdomAugust · Post time 2020-6-4 09:24:15

2.5 Program others2.5.1 Connect

Connect the mainboard and computer by serial port wire. Open software SecureCRT. Connect the correct “com” port.

Connect the computer and mainboard by USB cable.

WisdomAugust · Post time 2020-6-4 09:23:37

2.5 Program others2.5.1 Connect

Connect the mainboard and computer by serial port wire. Open software SecureCRT. Connect the correct “com” port.

Connect the computer and mainboard by USB cable.

WisdomAugust · Post time 2020-6-3 08:09:47

2.4 Install EmbedSkyDownLoadTool

Unzip EmbedSkyDownLoadTool_V1.0.rar file.

Double click the icon to install.

Click “Next”.

Select the path of file installation, click “next”.

Click “Install”.

Click “Finish”. If it warns that “.net4.0” is required to install at the beginning of the installation,

please unzip “dotNetFx40_Full_x86_x64.rar” in the programming folder. Double click and press enter key to install it.