Hantek 2D72 dead

Eltax1693 · Post time 2019-10-22 22:18:58

Hello
I only used my Hantek 2D72 a few times, and now it`s completely dead. Tried different batteries and cables, but no success. All updates installed. [Bought from Banggood]
Any suggestions?

Tnx

Eltax1693 · Post time 2019-10-23 16:40:38

Tnx for your replay. Do I need any special cable for this task?

Eltax1693 · Post time 2019-10-28 05:39:12

1: Amy, can you please supply the correct files and instructions how to connect?

2: Does this affects the calibration of the unit?

Tnx

Eltax1693 · Post time 2019-10-29 22:19:16

Edited by Eltax1693 at 2019-10-29 22:20

amy replied at 2019-10-29 11:49
May I ask what you have done, and then the device can not boot？
If you bought it before September 2 ...

Hello
The device can not boot.
I did nothing. It just died.

Eltax1693 · Post time 2019-10-29 22:28:11

Amy, Edmundturner and OASJ2YSeeEhBQo1 tnx for your help/support.

I waiting for the cable to arrive.

Eltax1693 · Post time 2019-10-31 05:37:08

Tnx for your advice. Sadley my unit is completely dead. Can not even power it on, and enter programming mode.
Still waiting for the cable.

Eltax1693 · Post time 2019-11-8 23:22:12

UPDATE: No success with my unit. Tried everything. Only used it a few times.