Hantek 2D72 dead

Eltax1693 · Post time 2019-10-28 05:39:12

1: Amy, can you please supply the correct files and instructions how to connect?

2: Does this affects the calibration of the unit?

Tnx

Eltax1693 · Post time 2019-10-23 16:40:38

Tnx for your replay. Do I need any special cable for this task?

OASJ2YSeeEhBQo1 · Post time 2019-10-23 07:57:41

Edited by OASJ2YSeeEhBQo1 at 2019-10-23 07:59

This seems to be a fairly common problem with this devices, the solution given by Hantek is to re-flash the firmware via a serial interface existant on the board (although I think it might be an easier solution but I need to test it).

https://www.eediscuss.com/forum. ... 18921&fromuid=26055

The link from the thread above with the files and instructions has expired, wait a bit that someone from Hantek will repost it to you, or try to email them directly.