Hantek 6022BL, button not working

tvellc · Post time 2019-8-25 00:40:55

Edited by tvellc at 2019-8-25 01:35

I have just started using the 6022BL unit. The oscilloscope works ok. But the P/H button, does nothing when I push it in or out. What is it for?

amy · Post time 2019-8-28 16:33:48

Please keep the key in H position. No need to change.

OASJ2YSeeEhBQo1 · Post time 2019-8-31 06:18:17

Leave the button pressed (H position) to use the oscilloscope with Hantek's USB driver and software. With the button in the position P (unpressed) the device will install the fx2 usb driver, then you can use the Saleae Logic software for the logic analyzer, it will be limited to 8ch only, but the Saleae software is much better than Hantek's.

Important! You need to unplug and plug again the device to the usb port every time you press the button for it to work.

https://www.youtube.com/watch?v=G5tFnaFK7qs

tvellc · Post time 2019-10-7 05:27:33

Thank you. This was the information I needed.