How to Use the Burst Function of HDG6000B?

WisdomAugust

1 Select the function and amplitude of the burst.

For burst waveforms, you can select sine, square, ramp, pulse, or arbitrary waveforms (noise is allowed

only in the “gated” burst mode and dc is not allowed). For this example, select a sine wave with an

amplitude of 200mV.

2 Select the burst mode.

Press and then verify that the “N Cycle” (internally-triggered) mode is currently selected.file:///C:\Users\ADMINI~1\AppData\Local\Temp\ksohtml5012\wps1.jpg

WisdomAugust

To Output a Burst

You can output the burst at a rate determined by the internal rate generator or the signal level on the

front-panel Sync/Mod/Trig connector. For this example, you will output a three-cycle sine wave with

a 10 ms burst period. You will not change the other parameters from their default settings: internal

burst source and 0 degree starting phase.