|
Hi,
as in title - I made the upgrade to last available firmware version and just after that the STOP/RUN button stopped to work correctly. When in the normal run (auto/normal) pressing this button does not stop the data acquisition (the button light is always green). If one press "single seq" then this button (after trigger) gets red and pressing it gives no effect... There is a beep sound so it is not the hardware problem (anyway, before the firmware upgrade this button had worked correctly). In order to restore some reasonable operation of the scope I have to restart it or at least press "auto set". This is extremely inconvenient...
Can you provide a corrected firmware or describe the way how to downgrade the scope firmware? The older firmware did not have this problem...
Thanks in advance.
Mariusz
|
|