Hantec 2D42 AWG Signal Generator - Offset does not work ?

ivesh

Hi,

I canot set the signal generator offset. Has anybody the same issue or am I doing something wrong ?
It does not work on the device and not on on the PC software. I can only set -0.5/+0.5 Volt
ps, I upgraded to the latest firmware today.
All help is appreciated ! Thx

OASJ2YSeeEhBQo1

The maximum output voltage of this AWG is +/-2.5V that is, amplitude+offset voltage must be <=2.5V. You set the amplitude of the waveform for 2V, thus the maximum offset will be 0.5V.

ivesh

Thank you !