DSO1062B Ethernet LAN

ying

Customer Consultaton
I recently acquired a Hantek DSO1062B Handheld Oscilloscope with SW version 2.01.1(170908.0) and HW version 1002.10x55558315. I was trying to use the ethernet jack on the device, but when plugged in to a network cable, the lights do not light up. In addition, under the System Features panel, it shows Net Card "Unsupported". I was wondering if there is a possible firmware update to fix this. Thank you.

ying

Reply
Please refer to "6.13 Example 13: Setting Net IP" chapter in manual to set net IP.
Manual download link: http://www.hantek.com/en/ProductDetail_1_13.html

timothyle97

I tried using the instructions in the manual, but I am unable to find "Pc set" under Utility->System. Screenshots are attached

ying

timothyle97 replied at 2019-5-6 15:06
I tried using the instructions in the manual, but I am unable to find "Pc set" under Utility->Sys ...

The LAN module is optional not standard. If you don't purchase together with the scope, there will be not this function.

timothyle97

ying replied at 2019-5-7 08:19
The LAN module is optional not standard. If you don't purchase together with the scope, there will ...

I understand, but I have a LAN module installed on the scope, as shown in the photos that I first included.

timothyle97

Hi, just wondering if there was any update on this. Thanks.

amy

Please open the system information window and take a picture to study.

timothyle97

Hi amy,

I have attached the system information window here. Thanks.

amy

Please send a message to me caiyijun@hantek.com