|
Edited by SpongeDon at 2019-3-27 05:28
Help,
I purchased a 6074BC, Loaded the Software and Driver on to my laptop. I then plugged in both USB(type A) into my laptop. The scope was showing only noise so I hooked up a probe to Ch1 and clipped onto the Cal output. A nice square wave resulted, and no problems to this point. Today I set up the scope to use it and can't seem to get it to work. I also noticed that the power led on the front panel of the scope wasn't lit today. It doesn't matter what sequence of hookups of the scope to the laptop, I never get the front led indication and no waveforms. I tried the whole procedure again on another laptop and I get the same failure(problem). Is there some kind of reset for the unit or procedure? The CH1-4 inputs have only been attached or probed the cal output of the unit at this point, so an overvoltage isn't possible. Both laptops show that A 6000 series is attached to the USB port. A little background, I'm a EE and Sr. Software Engineer with 30+ years experience, I'm not blowing my own horn, I'm trying to relay that you might not have to hold my hand t. Any ideas, or fixes? I've spent a good 5 hours on this problem. Thank you in advance, Don
Text-to-speech function is limited to 200 characters
|
|