DSO1202S a lot of problems / bugs.

stefan_c

Hi !

I've bought this instrument last october (-18) and started to use it last week. A lot of bugs has arised such as:

1) The USB memstick is not recognized on my PC (Win10) and this makes it impossible to do a firmware upgrade and saving waveforms and such.
2) The saving of waveforms (ch1 or ch2) isnt restored to correct place on screen, (if it is shown at all). If I save it on the memstick the PC doesnt find the file(s) ,
    why can I dont save both of them, only one is just useless.
3) I cannot connect to the PC via miniusb connector. (Digital Scope Software)

I start with these tre bugs, please respond ASAP.


Regards ....

Stefan

stefan_c

Hi Amy !

Thanks for you reply, much appreciated.  

I've reinstalled the driver and now I can work with scope on my PC. but the driver is called "Measurement Device" not DSO1000S or eq. It has the version 1.1.0.902 (c) 2007.  correct ?

And I had to do an wipe of the 4 Gb USB disk partition and create a new one. And success, now the instrument found the upgrade file and did the upgrade.
But after the updates the fan has started to run and make a terrible buzzing sound, when I tilt the instrument it sounds even louder, what shall I do about that.

Again,  thanks for your tip and help.

Regards ...

Stefan