Hantek2000 bugs and wishes (2c42,2d42,2c72,2d72)

jonb123 · Post time 2019-11-24 11:45:44

In X-Y mode, is there some way to enable "vector" mode? All I get are "dots", which is almost unusable in my application. I tried using the PC software and it too only does "dots" when in X-Y mode. It would be GREAT if X-Y mode did vectors.

jonb123 · Post time 2019-11-26 02:21:22

Is there a way to disable the display "dimming" after a fairly short period? I really find it annoying as the device becomes unusable while dimmed. I have adjusted the timeout and backlighting but the display dimming partway through the timeout is what I would like to disable.

Svyatoslav · Post time 2019-11-26 04:12:01

amy replied at 2019-1-4 10:20
About the calibration problem, please refer to the following post and download the latest firmwar ...

Подскажите пожалусто. После неудачной прошивки, пришлось устанавливать чужой дамп чтобы востоновить свой 2с42, после этого он загрузился но работать стал странно. Обновил прошивку до 2019110801, но в режиме GND показывает не ноль а минус. Это нормально?
Прошивка последняя. Как это исправить?
В режиме gnd он показывает max-5,12 min -5,12
Вот видео проблемы: https://yadi.sk/i/gW9qoQf19nLceg

jonb123 · Post time 2019-11-26 06:02:09

Figured out the dimming -- set the time to infinite.

AxGxP · Post time 2019-12-4 23:00:10

what about make menu hide on pressing "Enter" or "Menu" second time?
Change button Left<->Right in Channel Mode (voltage/division)?
Change button Up<->Down in Time Mode (seconds/division)?

Is it so hard to make this changes?
Please! Do it!

amy · Post time 2019-12-12 14:12:48

I'm sorry, but the engineer hasn't arranged the time to modify it yet.

AxGxP · Post time 2019-12-13 07:03:41

amy replied at 2019-12-12 14:12
I'm sorry, but the engineer hasn't arranged the time to modify it yet.

I modified it already by my self...
Its a pity that thous engineer work in Hantek.

DeeGee · Post time 2020-2-11 04:52:27

Edited by DeeGee at 2020-2-11 04:54

When using the Cursor in Time mode, it would be helpful if the unit could toggled between time-difference and frequency (1/time) in the "Increment" result. Maybe pressing F3 could toggle between time and frequency. It would avoid having to do the math off the device to calculate a frequency with the cursor.

SirBrian · Post time 2020-2-20 04:52:07

I would like to see a trigger delay added to the 2d72

any1ne · Post time 2020-4-20 13:58:48

Edited by any1ne at 2020-4-20 14:26

Amy, please, add horizontal scale settings during operation. At least option to see all the signal on the screen but not a part of it, like on the picture below.
On a slow scan, measurements are very poor and uncomfortable.

Hantek2000 bugs and wishes (2c42,2d42,2c72,2d72)

This post contains more resources

Comments

This post contains more resources